12
6.
PROGRAMMING MODE: PROGRAMMING DIVICE
Your EPA300 process controller operates in two different modes. Your device is in
'operating mode' while the initial value of the sensor readout is displayed; In the
'programming mode' on the screen where the settings are changed and the parameters are
changed. In this section, the functions in Programming Mode are explained.
To switch your device from working mode to programming mode Press and hold
PRG until OUT appears in the display. To return to the operating mode, press the ESC key
repeatedly until you return to the operating mode. While your device is in Programming
Mode
;
-
To scroll between menus, press the DOWN and UP keys
-
Press enter (PRG) to enter any menu.
-
Use the ESC key to exit from any menu and return to the upper menu.
-
When entering any parameter value, press the DOWN key to dicrease, press the UP
to increase the value. Press and hold the keys to move to the next or previous digit.
The EPA300 consists of 4 main menu items: Output, Secure, Display and Calibration.
6.1
Output Menu [OUT]
6.1.1
1. Relay Output Setting (OUT-1)
6.1.1.1
Entering the Set Value
The first relay output activates and sets the value of the lit LED of the status SET1.
(
Keep it pressed)
The decimal point
starts flashing. Use
the UP and DOWN
keys to select the
decimal point.
.
Press and hold the UP and DOWN
keys to move to the next step. To
enter a
negative (-) value, press
the
DOWN key to come to one of
the
non-digitized steps.
When PRG key is
pressed and entered,
the value input screen
opens. Enter the
desired value using
the UP and DOWN
keys.
.
The new S-LO value you confirmed with the PRG key has been
set. Press UP to move to S-HI.
