Eskon EPA300, Руководство пользователя

Страница: 10 / 21

10
5. OPERATING MODE: FUNCTIONS
Your EPA300 process controller operates in two different modes. Your device is in
'operating mode' while the initial value of the sensor readout is displayed; In the
'programming mode' on the screen where the settings are changed and the parameters are
changed. In this section, the functions in operating mode are explained.
5.1 Tare Function
***Only works when the Tare function is active. For activating or explaining the types of functions,
6.3.2 Setting the Tare Function
Each time the UP key is pressed while the unit is in the operating mode, the Tare function is
activated according to the type of the selected function and the
Tare status lights up.
5.2 Viewing the Maximum and Minimum Reading Values
If you press the DOWN key while the unit is in operating mode, you can see the lowest
(minimum) value read from the moment the unit starts to operate. At the same time,
Min
status will flash on the screen.
When you press the DOWN key again, you can see the highest (maximum) value read from
the moment the device starts to operate. At the same time
Max will be on the screen.
5.3 Changing Quick Set Values
Press and hold the ESC key to quickly change all adjustable setpoints while the unit is
in run mode. You can then change the desired SET value by pressing the PRG key. When
entering a value, press and hold the UP and DOWN keys to move to the next step. To enter a
negative (-) value, press the DOWN key to come to one of the non-digitized steps.
5.4 Transition to Programming Mode
To switch your device from working mode to programming mode

.
 
.
 
.

( Keep it pressed)



1
2
3

.

 . 
4
5
6