12
Kongsberg XN / iPC 2.0
100
12.8.9 Bit Slipping, Chuck Change
Even though the
chuck
is expected to have a long lifetime, replace it immediately if you
experience any problems as:
1.
Bit slipping.
2.
Bit vibrations.
When replacing the
chuck
, follow instructions in
Chuck Change and Clean
.
New
chucks
are available from Esko store.
12.8.10 Bit Length and Position
Keep distance d small.
For best performance and minimum wear, do
not let the bit stick out more than necessary.
Use bits with short cutting lengths for thin
materials.
For proper clamping, keep distance e 20 mm,
0.8 inch as a minimum.
To achieve material through-cut, the distance d
must be at least 18 mm, 0.7 inch.
Balanced Bits
Bits with balanced surface should have a
clamping length f of min. 20 mm/0.8 inches.
