12
Kongsberg XN / iPC 2.0
90
Maintain bit clamping
Un-proper
bit clamping
may cause the bit to
slip in the
chuck
and damage the
Table Top
.
1.
Keep the
bit shaft
clean.
2.
Avoid greasy fingers.
3.
Clean the
bit shaft
with acetone if
necessary, but use only dry cotton tips on
the chuck.
4.
Maintain
Pressurized Air
supply of 7 bar.
5.
Follow procedures strictly:
Chuck Change
and Cleaning
on page 96.
Long term storage
More than 4 weeks storage of a spindle or a
MultiCUT
/
MultiCUT-HP
requires:
1.
Turn the spindle by hand about 20 turn
every 4 weeks.
2.
Spindle must be stored horizontally.
Consider having a replacement spindle
If
MultiCUT-HP
is used in regular production,
it is recommended to have a
Replacement
Spindle
.
The service interval will depend on the type of
operation, and is difficult to predict.
Indication of worn bearings may be increasing
noise, increasing vibrations or decreasing
surface finish.
Note:
When replacing a
Spindle
, torque the
motor clamp to 5 Nm, 44 lbf-in using a
Torque
Wrench
.
This is a low torque for that screw size.
Also check by hand that the
Spindle
rotates
smooth without any resistance.
