Eskabe DVEL 12, Руководство владельца по эксплуатации и установке

Страница: 6 / 25

5
INSTALLATION (CONTINUED)
This appliance may be installed in an aftermarket, permanently located, manufactured home (USA only) or
mobile home, where not prohibited by local codes.
This appliance is only for use with the type of gas indicated on the rating plate. This appliance is not
convertible for use with other gases, unless a certified kit is used.
IMPORTANT :
This appliance should only be installed by a qualified installer.
The installation must conform with local codes or, in the absence of local codes, with the
National Fuel Gas Code,
ANSI Z223.1, or Canadian Installation Code, CAN1-B149.
Installer l’appareil selon les codes ou règlements locaux, ou en l’absence de tels règlements, selon les codes
d’installation
Canadian Installation Code, CAN1-B149.
A manufactured home (USA only) or mobile home OEM installation must conform with the
Manufactured Home
Construction and Safety Standard, Title 24 CFR, Part 3280 , or, when such standard is not applicable, the Standard for
Manufactured Home Installations, ANSI Z 225.1 , or Standard for Gas Equipped Recreational Vehicles and Mobile
Housing, CSA Z 240.4.
IMPORTANT
•
The appliance area must be kept clear and free from combustible materials, gasoline, and other flammable
vapors and liquids.
•
Due to high temperatures, the appliance should be located out of traffic and away from furniture and
draperies.
•
Children and adults should be alerted to the hazards of high surface temperature and should stay away to
avoid burns or clothing ignition.
•
Young children should be carefully supervised when they are in the same room as the appliance.
•
Clothing or other flammable material should not be placed on or near the appliance.
•
Any safety screen or guard removed for servicing an appliance must be replaced prior to operating the
appliance.
Installation and repair should be done by a qualified service person. The appliance should
be inspected before use and at least annually by a qualified service person. More frequent
cleaning may be required due to excessive lint from carpeting, bedding material, etc. It is
imperative that control compartments, burners and circulating air passageways of the
appliance be kept clean.
WARNING:
Failure to position the parts in accordance with these diagrams, or failure to use only parts
specifically approved with this appliance may result in property damage or personal injury.
AVERTISSEMENT: Risque de dommages ou de blessures si les pièces ne sont pas installées conformément à
ces schemas et ou si des pièces autres que celles spécifiquement aprouvées avec cet appareil sont utilisées.
INSTALLING THE APPLIANCE
Separate the hanging bracket from the appliance by removing two screws on the top and two nuts at the bottom.
INSTALLING THE HANGING BRACKET ON A NON-COMBUSTIBLE WALL (i.e., MASONRY
BLOCK OR CONCRETE)
1. Draw the position of the hole for the air-vent intake pipe, taking into account the minimum clearances mentioned in
figure 4. See diameter of the hole “D” and height to the center “C” in table 1 and figure 5 for the different models.
Height “C” is the minimum recommended.