8
2. Nose Flats Rebuild
• Place the ESCO nose flats template over the nose as shown.
Weld buildup nose flats and radii, and grind flat until template
contacts nose end.
CAUTION:
Weld beads must be oriented parallel to the nose end.
Nose flats template
Nose side
template
Nose Rebuild – All Sizes
Nose Fit:
The S-Series Posilok
®
tooth system is designed to operate with
movement of the adapter on the nose. However, movement may become
excessive over long term service because of nose wear. In this event, the
nose can be rebuilt in the indicated areas with welding and grinding.
IMPORTANT:
Perform Step 1 using the nose side template, Step 2 using the
nose flats template, and step 3 using the 3D nose template.
Nose end
Nose radii
Nose
sides
Nose
flats
Rear nose
corners
1. Nose End and Sides Rebuild
• Place the ESCO nose side template on the centerline of nose. Weld
rebuild nose end surface and grind flat until gage ends align with front
edge of pin hole.
Note:
Refer to ESCO Weld Procedures P6000GEN. Weld stringer beads
should run parallel to the nose width.
• Rebuild nose end radii as necessary.
