5
ElectraGlide Instruction Manual
CHARGING THE FLIGHT BATTERY
The charger is designed to automatically charge the Li-Po battery in about 1 hour from a discharged state. The 12V DC
automatic charger is powered by the mains power supply illustrated above. Alternatively, you can use a 12 volt sealed
modelling battery to power the DC automatic charger..
1.
Connect the mains power supply to your wall
socket and the other end to the charger.
The LED on the charger will glow
GREEN
showing power is available..
2.
Insert the white JST plug attached to the
battery into the white socket on the charger.
Make sure it is fully connected.
Charging:
Whilst charging LED fl ashes
RED
Fully charged:
Fully charged LED is solid
GREEN
.
3.
When the battery is fully charged disconnect
the battery from the charger. Disconnect the
power supply from charger and the wall.
Your LiPo battery is ready for use
4.
Alternatively you can connect the charger
to a 12V lead acid battery or 12V switched
power supply using the supplied lead.
DC power leads
Li-Po charger
Li-Po battery
Mains power supply
for charger
