4
4.
Attach Strut Tubes (#17) and Linkages (#16) to Caster Beam Assemblies (#8) as shown in
Figure 4
.
a)
Loosen Bolts (#13) and Nuts (#28) so that Strut Tube (#17) can fit between Support Plate (#43) and Caster Beam (#8)
as shown in the
Top View
and
Figure 4
.
b)
Slide one Hex Bolt (#27) through Caster Beam (#8), one Plastic Washer (#39), Strut Tube (#17), Plastic Washer (#39),
Support Plate (#43) Spacer (#36), Linkage (#16) and Locknut (#28) as shown in
Figure 4
and
Top View
.
c)
Repeat on other end of Caster Beam (#8) and on second Caster Beam.
d)
Tighten Bolts (#13) and Nuts (#28) (installed in
Step 2
) securely.
e)
Tighten Nuts (#28) on Bolts (#27) securely but
DO NOT
over tighten, Strut Tube
must Pivot Freely.
Top View
27
39
36
28
17
43
12
16
13
13
8
3.
Attach Wood Bottom Board (#15) to Caster Beam Assemblies (#8) as shown in
Figure 3
. Turn
Caster Beams as shown and attach board with four Carriage Bolts (#31) and four Wing Nuts (#32).
Tighten Thumb Screws securely.
Note
: Linkages and Strut
tubes must be turned as
shown or table will not
operate correctly.
8
16
17
16
27
36
28
39
17
Note
: Support Plate (#43)
must be on inside of Caster
Rail (#8) as shown.
8
43
15
8
32
32
31
31
Figure 3
Figure 4
28
