14
Raise Backboard to 10 FT. regulation playing
height. Measure from top of rim straight down
to the playing surface.
Using tape - mark the
side
of the steel actuator
(#16) just under the plastic actuator sleeve
(#15) at this 10 ft rim height. See
Figure 15
.
Lower backboard all the way down. Do not force
actuator once backboard is in it's lowest position.
See
.
Figure 16
Do not
remove adhesive backing from height
decal (#17) yet. Carefully place height decal on
backside of steel actuator
and line up the
(#16)
10 ft mark on the tape with the 10 ft mark on the
height decal. Decal should fit correctly onto the
backside of the steel actuator. ( If not , simply
trim to fit the top of the actuator decal).
30.
31.
32.
33.
34.
Remove the adhesive backing from the Height Decal (#17).
Next, carefully align and stick decal to backside of steel
actuator (#16) starting at the
. Be sure to
10 ft mark first
keep the height decal straight and rub out all air bubbles. See
Figure 17
.
Set at 10 feet
Mark with
tape
15
Figure 15
Lowered all
the way down
Tape at
10 feet
Figure 16
15
Tape
17
16
15
Figure 17
