5 OPERATION
0446 404 001
- 14 -
© ESAB AB 2020
S.no. Name
Function
1
Ending arc current
/ Crater fill current
Adjusts the crater fill / Ending arc current in 4T and 4T repeat
mode
2
Ending arc voltage
/ Crater fill voltage
Adjusts the crater fill / Ending arc voltage in 4T and 4T repeat
mode
3
Arc force
The arc force is important in determining how the current
changes in response to a change in the arc length. A lower value
gives a calmer arc with less spatter. It only applies to MMA
welding.
4
Inductance
Sets the dynamic of arc. The lower inductance will give softest
arc and higher inductance will give hardest arc.
5
Wire diameter
Selects the diameter of the welding wire. Only applicable for MIG
welding
6
Welding process /
Wire type and gas
Selects the welding process
• Solid wire-CO2, (MIG/MAG)
• Solid-Mix gas, (MIG/MAG)
• Cored wire (MIG/MAG)
• MMA welding
If MMA mode to be selected, press and hold for 2 seconds. To
come out from MMA mode again press and hold for 2 seconds.
7
Welding control
Selects the welding control mode.
8
Gas detection
Detects gas flow.
9
Value adjusting
knob
Manually adjusts
• the current for MMA process
• the ending arc voltage, ending arc current, Inductance for
MIG/MAG process and
• the current and voltage within specified ranges.
