5 OPERATION
0446 404 001
- 13 -
© ESAB AB 2020
5
OPERATION
General safety regulations for handling the equipment can be found in the "SAFETY"
chapter of this manual. Read it through before you start using the equipment!
NOTE!
When moving the equipment use intended handle. Never pull the cables.
WARNING!
Electric shock! Do not touch the workpiece or the welding head during operation!
5.1
Connections and control devices
1.
Connection (+): MIG/MAG: Welding
cable, MMA: Welding cable or return
cable
6.
Fuse for the gas heater input supply
2.
2. Connection (-): MIG/MAG: Return
cable, MMA: Return cable or welding
cable
7.
Mains power supply switch, ON/OFF
3.
3. Indicating LED, Overheating
8.
Mains cable inlet
4.
Connection of wire feed unit
9.
110V AC power supply socket for gas
heater
5.
Circuit breaker 10A (wirefeeder motor)
10.
CAN communication connector (Factory
use)
The following figure shows the front control panel and the buttons on the control panel of the
welder.
