Erskine Attachments WOOD CHIPPER 9, Руководство оператора

Страница: 10 / 30

5 9" SKID STEER CHIPPER
1
2
3
4
5
1
2
4
5
6
2 ASSEMBLY
2.1 ATTACH DISCHARGE TUBE
WARNING
If any bolts or nuts are dropped in the machine, be sure to remove them before starting the machine.
1. Attach one clamping ring (1) and one spacer ring (2) to
discharge tube base (3) using three 3/8" × 1-1/4" bolts
(4) and nylock nuts (5). Tighten leaving 1/16" gap to
assist in mounting to flange. See Figure 2.1.1.
2. Slide the tube onto the mounting flange on the chipper
frame. The discharge clamp (1) should slide underneath
the lip of the flange. Tighten the bolts to secure it.
3. Install the second half of the spacer (2) and clamp ring
(1) on the discharge tube with 3/8" × 1-1/4" bolts (4)
and nylock nuts (5).
4. Attach lanyard with discharge pin (6) as shown in
Figure 2.1.2. Loop on lanyard installed below nut
located under discharge handle.
5. Lubricate the tube by applying grease to the grease
zerk at the base of the tube. Rotate the tube and apply
grease until the tube rotates freely.
6. Rotate the tube 360 degrees and lock it in place with
the lock pin to make sure it is mounted correctly.
Figure 2.1.1, Attach Clamp Ring and Spacer
Figure 2.1.2, Attach Discharge Tube
NOTE
Keep nuts as tight as possible while allowing the discharge
tube to freely turn.