Eriez FJ-310A, Инструкции по установке, эксплуатации и обслуживанию

Страница: 6 / 28

6
Sump Cleaner Warranty
(cont.)
Eriez HydroFlow shall not be liable for any damage
to or loss of any cutting fluids or for loss of any income
or profits due to the malfunctioning of the equipment
hereinafter described, whether the malfunctioning is
caused by defects in factory workmanship and/or
faulty material, or any other cause whatsoever.
Component parts returned for replacement must
show the original unit serial number from which
they were removed. Parts returned without the
aforementioned serial number will be replaced at
established replacement prices. This warranty does
not cover equipment damaged by misuse, negligence
or accident. Vacuum and pressure relief valves are
preset at the factory. ALTERATION OF THE SETTING
EXCEPT WITH THE SPECIFIC AUTHORIZATION
OF ERIEZ HydroFlow OR ITS AUTHORIZED
REPRESENTATIVES WILL VOID THIS WARRANTY. 1. Remove the cover of the basket. Keep hands and
fingers from under the filter basket gasket. Take
out the following items:
A. Filter basket (factory assembled with sleeve)
B. Discharge hose with nozzle
C. Suction hose
D. Cleaning tool
E. Spare filter sleeve or filter bags
F. LP bottle brackets (on LP models)
2. Check the locking pin that holds the filter basket’s
trapdoor shut. Make sure it is securely in place
(fully extended as shown in the drawing at the
end of the manual).
3. Keeping hands and fingers from under the basket
lip, reseat the filter basket in the tank. Replace the
tank lid and clamp it down.
4. Attach the suction hose to the intake connection
on the tank lid. Attach the cleaning tool to this
hose, then coil the hose around the push handle
or hose hangers provided at the basket end of the
tank. Place cleaning tool in pipe holder attached
to the side of the tank.
5. Couple the discharge hose to the discharge
connection on the side of the tank and coil it over
the push handle or hose hangers provided. Make
sure the discharge nozzle assembly is installed
on the other end of the hose.
6. On LP models, remove the bolts from the side
of the base plate and mount the bottle brackets
on the plate using the bolts provided.
Assembly