Eriez FJ-310A, Инструкции по установке, эксплуатации и обслуживанию

Страница: 10 / 28

10
lp Gas Dual Tank Models
Operation
1. Before operating this equipment for the first time,
and periodically thereafter, review the SAFETY
INFORMATION beginning on page three of
this manual.
2. The standard sump cleaner LP gas engine
is equipped with LIQUID WITHDRAWAL
regulators for use with either LIQUID or VAPOR
WITHDRAWAL LP GAS BOTTLES.
3. Suction and discharge cycles are controlled by a
four-way valve in the piping from the SUCTION/
DISCHARGE pump to the tank. Placing the valve’s
control lever in the horizontal position selects the
SUCTION mode (FIGURE II-A). Moving the lever
a quarter turn to the vertical position selects the
DISCHARGE mode (FIGURE II-B).
FIGuRE II-A
Suction/Discharge lever - SUCTION position
FIGuRE II-B
Suction/Discharge lever - DISCHARGE position
4. Suction vacuum or discharge pressure is applied
to both tank compartments simultaneously. No
valves are used to select one tank compartment
from the other. Select the compartment to be used
by attaching the suction and discharge hoses to the
proper fittings on that tank compartment. Cap off all
other fittings.
5. For dirty fluid suction operation: Activate the
Pull out for CHOKE Turn key to START
float switch for the compartment selected by
setting the TANK OVERFILL PROTECTION
SELECTOR SWITCH to the appropriate position.
This float switch prevents over-filling of the
compartment and pump damage during the
suction cycle by turning off the engine’s ignition
circuit at a predetermined liquid level. Make sure
all 1-1/2" female quick disconnect caps are
installed on the male fittings on the clean side
and the dirty side discharge ports.
A. Place the SUCTION/DISCHARGE lever in
the horizontal (SUCTION) position. Open the
LP Gas bottle valve. Open the suction inlet ball
valve. Place choke in “ON” position. Turn
ignition key to the “START” position while
moving choke to the “OFF” position. Release
key when the engine starts and move choke
to the “OFF” position.
B. Vacuum coolant and chips from the sump.
C. As soon as fluid stops passing through the
hose, stop the engine by turning the IGNITION
switch OFF. Close the gas bottle valve. This
valve must always be closed when engine is
not running.