Ericsson TANDBERG Television iPlex N20001, Руководство по установке, Страница: 82 / 98

82
iPlex Installation and Hardware Specification Guide
Option 10 Go to boot from prompt gives you debugging commands.
Choose an option: Type “10” and the following prompt will appear.
SCM<bootrom>-> Type “help” <CR>
help - print online help
reset - perform RESET of the CPU
bootm - boot application image from memory
setenv - set environment variables
If you want to go back to the options screen, type:
reset <CR>
You will see the scroll of parameters and the router will count down 10 seconds. If
you want to interrupt this command, you must type
Ctrl X Ctrl W <CR>
.
After completing your configuration, you must boot the iPlex by typing
0 <CR>
.
You will see the following message:
Press break sequence <^X ^W> <CR>
in 10 seconds to stop autoboot.
Again, if you want to interrupt this command, you must type
Ctrl X Ctrl W
<CR>
.
When the iPlex boots, it will load the software image from the designated location.
The screen will show the various software elements as they load and finally end at
the login prompt used for cli commands.
iplex login: Type “root” <CR>.
Password: Type “******” <CR>.
[root@iplex] Type “?” <CR>.
For more information on how to configure the iPlex using CLI, see the iPlex
Command Line Interface Reference Guide.
Example If you want to change Management PC’s IP address:
[root@iplex] Type “config” <CR>
[config#] Type “system {“ <CR>
[system config#] Type “managementIp {“ <CR>
[system managementIp config#] “ipAddress 192.168.58.69” <CR>
[system managementIp config#] “netmask 255.255.255.0” <CR>