Ericsson TANDBERG Television iPlex N20001, Руководство по установке, Страница: 81 / 98

iPlex Installation and Hardware Specification Guide
81
The initial steps of installation are as follows:
•
Give the SCM an IP address
•
Setup the root password
•
Enable the boot image
•
Set date and time
At Choose an option: Type “1” and press Enter .
Enter the IP address for the board <192.168.4.41>
:
Type the IP
address in the xxx.xxx.xxx.xxx format and press Enter .
Enter the Subnet Mask <<NULL>>:
Type the subnet mask in the
xxx.xxx.xxx.xxx format and press < CR > .
Enter the Default Gateway <<NULL>>:
Type the default gateway in the
xxx.xxx.xxx.xxx format and press < CR > .
After this, the initial screen will display again.
Choose an option: Type “2” and press < CR > .
Enter the ROOT password <MIN:6 MAX:12>:
Type your password ********
and press < CR > .
Re-Enter the ROOT password <MIN:6 MAX:12>:
Type your password again
******** and press < CR > .
The initial screen will appear again.
Choose an option:
Type one of the following “5, 6, 7 or 8” and press < CR > ;
or leave the default in place.
If you typed “6”, the following will appear:
Enter the TFTP server IP address <192.168.4.43>:
Type the IP
address in the xxx.xxx.xxx.xxx format and press < CR > .
Enter the TFTP file Name <max: max 128 chars> </tftpboot/lat-
est/mediapiPlex-image>:
Type in a new path for the boot image or press
< CR > to accept the default.
If you have a PMCIA disk in the SCM, you can boot from that image. If you
choose an option that does not exist, the initial screen will return. To choose
option 7 or 8, the SCM will boot from the internal flash boot image.
NOTE
The IP address in brackets shows the last IP address entered. Also
Enter is shown as <CR>.
NOTE
To accept the IP address in brackets just press Enter.