Ericsson AVP 1000 1RU, Справочное руководство, Страница: 49 / 508

Getting Started
EN/LZT 790 0023/1 R16A
3-7
•
after loading a profile (unless Support > Save Configuration > Save
configuration including control parameters and Support > Restore
Configuration including Control Parameters web GUI options are used).
Limitations
In-band Control enables you to perform most of the usual configuration, control and
monitoring functions, but has the following limitations:
•
The Control port is not supported when using In-band Control mode.
•
The In-band Control feature is only supported for the following network
configuration:
- Data Output ports configured as Same-Network.
- Data Output ports configured as Active/Active.
- The physical IP address need not be set be set on the Data Output ports.
When In-band Control is enabled, the value configured at
Device
Configuration > Advanced Setup > Network Configuration > Data
Interface Group 3-4 > IP Address
shall be valid for HTTP, SNMP, NTP,
Unit Upgrade, ssh and License Key Generator.
•
If a unit upgrade fails resulting in the unit going into factory mode, all data
network access will be lost. It will therefore be necessary to retry the upgrade
using the unit’s Control port. If you have no Control port network, it will be
necessary upgrade the unit locally.
•
No reboot warning dialog appears when the In-band Control setting is changed
on the front panel. A warning dialog will be presented, however, if the setting is
updated on the web GUI.
•
The following features are not available when using In-band Control mode:
- LDAP
- Remote logging
- SCTE 104 over IP
- ESAM
- CSM messaging for MGP
3.4.1 How to Configure In-band Control Using the Front Panel
Configuring In-band Control is accomplished using the front panel menus. For a full
description of these menus, see
Chapter 4, Front Panel Control .
To configure In-band Control on the unit(s):
1. Ensure the unit is fully powered up.