Ericsson AVP 1000 1RU, Справочное руководство, Страница: 112 / 508

Getting Started
3-70
EN/LZT 790 0023/1 R16A
3.25.2 How to Configure Audio Parameters
Audio Input Parameters
To configure the audio input parameters, select the AVP Encoder /Audio
Module/Audio n /Input menu and set the parameters as listed in
Table 3.19.
Table 3.19 Audio Input Settings
Parameter Settings
Input Format Uncompressed (LPCM), Dolby Digital, Dolby E,
Input Source Off, Mute, Test Tone, Embedded 1-8, Input 1-4. Analogue 1-2.
Output on Audio Loss Silence, No PID
Audio Encode Parameters
To configure the audio encode parameters, select the AVP Encoder /Audio
Module/Audio n /Encode menu and set the parameters as listed in
Table 3.20.
Table 3.20 Audio Encode Settings
Parameter Settings
Coding Standard MPEG Layer II, Dolby Digital, AAC, Pass-thru (Options depend on licenses)
Bitrate Range depends upon selected coding standard
Coding Mode Available options depend on selected coding standard.
The parameters of the encoding can be configured in a sub menu whose name
depends on the Coding Standard chosen. Set up the encoding as needed.
Note: The number of audios available for configuration will depend upon the
number of licenses.
3.25.3 How to Set Up a Transport Stream
A Transport Stream is made up from one or more services. A service is made up
from one or more components. To build a Transport Stream to be sent to the output,
proceed as follows:
1. Select the Output menu.
2. Select the output to which the Transport Stream is to be sent.
3. Select Transport Stream ID: 1 if available, otherwise Select Add Transport
Stream .
4. Check that the parameter settings are correct.