Ericsson AVP 1000 1RU, Справочное руководство, Страница: 266 / 508

Web GUI Control
5-90
EN/LZT 790 0023/1 R16A
Parameter Values Description
AS Index Control Don't Care, Use 1, Use 1 + 2
Only available when Splicing Control is set to On VANC
Message Only .
If set to Don’t Care the AVP will create SCTE 35 output
regardless of the source Automation System.
If set to Use 1 the AVP will create SCTE 35 output only for
incoming SCTE 104 whose AS Index matches the setting
in
AS Index 1 .
If set to Use 1 + 2 the AVP will create SCTE 35 output only
for incoming SCTE 104 messages whose AS Index
matches either the setting in
AS Index 1 or the setting in
AS Index 2 .
DPI PID Index Control Don't Care, Use 1, Use 1 + 2 Determines how many values of DPI PID Index are
compared against the incoming SCTE 104 message.
Available only when Splicing Control is set to On VANC
Message Only.
AS Index 1 0 to 255 The AS index used if AS Index Control is set to Use 1 or
Use 1 + 2.
AS Index 2 0 to 255 The AS index used if AS Index Control is set to Use 1 + 2.
DPI PID Index 1 0 to 255 The DPI PID index used if DPI PID Index Control is set to
Use 1 or Use 1 + 2.
DPI PID Index 2 0 to 255 The DPI PID index used if DPI PID Index Control is set to
Use 1 + 2.
Splicing Component
The following parameters are available on the Component tab of the Properties
widget on the Service Configuration page when an SCTE 35 stream is selected in
the Outputs widget. The same parameters can be accessed through the
Output/<output name>/Transport Stream ID: <n>/Service List/<service
name>/Component List/<component name>
menu on the front panel.
Table 5.64 Slicing Component Parameters
Parameter Values Description
PID 32 to 8190 Sets the packet identifier associated with the component.
Bit Rate Weighting Fixed Specifies the weight associated to the component in the
Bit Rate Tracking algorithm. For audio stream, this is Fixed
and read only.
5.5.3.3.4 Teletext Stream Configuration
This section describes the parameters for setting up Teletext.
Teletext
This section gives the parameters that have an effect on how Teletext is transmitted.
The following parameters are available on the Teletext tab of the Properties widget on the
Service Configuration page when a Teletext stream is selected in the Outputs widget. The
same parameters can be accessed through the Advanced/CE-x/Video/Video 1/Input/VBI
Extraction/Teletext menu on the front panel.