9/21
6
8hrs
a
c
b
7 hrs
07.00
EN
888-24-092-G-02 rev. H • 05/11
Battery Charge/Discharge
Initial Power on/Charge Battery
(takes aproximately 7 hours to charge)
Turn on power system by holding power buttondown for 1 - 3 seconds.
With cart's power cord plugged into the wall outlet, wait until cart
is at 100% charge. (takes aproximately up to 7 hours to charge)
Plug Cart's Power Cord into wall outlet.
Do Not stretch coiled cord further than 8 feet
(2.5 meters), damage to the cord may occur.
When lit, alarm is enabled and
will beep when battery charge
gets below 30%. For details on
enabling and disabling alarm
contact Ergotron Customer Care.
When lit, the power system is on.
When dark, power system is off .
This power system interface will alert you to the percentage of charge remaining in the cart battery with a series of steady or fl ashing
red, yellow or green lights, and an alarm that will beep when charge gets below 30%. Remember, the battery needs to be charged to
100% every day, and you can use the cart while charging, so plug-in cord as often as possible to avoid running out of power!
NOTE: Put monitor in power save mode to optimize battery run time.
Battery has 100% charge.
Light fl ashes when charging (power cord plugged into wall outlet)
Allow battery to continue
charging until light stops fl ashing. After light stops fl ashing, it is OK to unplug the
power cord from the wall.
You can use cart while charging.
Battery has less than 90% charge.
Battery has less than 70% charge.
Battery has less than 50% charge.
Battery has less than 30% charge. Light is red and alarm beeps. Plug-in power cord and charge
to 100%! You can use cart while charging.
Alarm Mute button. Pressing this will temporarily mute alarm.
Power button for internal power system outlets. Pressing this will provide or remove power to/
from components plugged into the internal outlets.
NOTE: Frequent operation of the cart while battery charge levels are
below 30% will signifi cantly reduce the life of your battery and may
void your battery warranty.
CAUTION:
There is no on/off switch on
this equipment; the AC power cord is the only
power disconnect. The socket outlet should be
easily accessible and should be installed near the
equipment.
Note: If StyleLink is installed, it will report battery status “checking” until battery has gone through one full cycle (charge to 100%, discharge to
< 70%, and then plug cart into wall outlet). After battery has gone through one full cycle, StyleLink will provide battery status. In the event that
StyleLink still reports status “checking’, repeat the discharge / recharge and plug in.
