Two people are required for this step.
NB.
Do not release the fl at panel until verifying
the connection between the universal mounting
brackets and the upper and lower mounting bars.
Place the universal brackets and the fl at panel over
and onto the upper and lower mounting bars of the
EMPRO-WM175B and lower it down. Do not release
the fl at panel until the fl at panel is resting securely
on the upper and lower mounting bars.
Securing and Levelling the Flat Panel
In the event that the fl at panel is tilted too far to
one side, the levelling screws will allow you to
compensate for this tilt by simply adjusting the
screws with a screwdriver. (see illustration for a
clearer view).
Use a screwdriver to adjust the two M6 x 30 levelling
screws, located on the top of the mounting brackets.
Once the fl at panel is level, use a screwdriver to
tighten the two M6 x 30 locking screws, located on
the bottom of the mounting brackets. Do not over
tighten these screws.
Adjusting the Flat Panel Tilt
NB.
To adjust the tilt tension of the EMPRO-WM175B,
loosen the tension bolts located on the bottom right
and left side of the main arm assembly. Re-tighten these
bolts to achieve your desired tension.
Adjusting the Flat Panel Down
Place one hand at the centre top edge of the fl at
panel.
Place the other hand on the centre bottom edge of
the fl at panel.
Using the upper hand, gently pull the top of the
fl at panel away from the wall while the lower hand
gently pushes the bottom of the fl at panel towards
the wall.
Attaching the Flat Panel to the Wall Plate
Upper
Mounting
Bar
Lower
Mounting
Bar
Flat Panel
1
1
2
Screwdriver
Levelling
Screw -
Pre-installed
Locking
Screw -
Pre-installed
Tension Bolt
Installation
1
1
2
3
9
