Installation
1
Adaptor Plate Installation
1
2
3
4
5
NB.
The adaptor plates can be used with mounting
patterns from 200mm x 200mm to 650mm x
840mm.
NB.
In the event that your fl at panel has recessed or
an uneven mounting surface, universal spacers may
be stacked to achieve proper spacing. Select the
amount og universal spacer that is closest in depth
to keep your adaptor plate as close to the fl at panel
as possible. The universal spacer must be secured
between the fl at panel and the adaptor plates.
Do not overtighten the screws.
Determine if your fl at panel will need the adaptor
plates.
Locate the mounting points on the back of the fl at
panel.
Using a screwdriver, insert and tighten the mounting
hardware and adaptor plates to the back of the fl at
panel. Do not overtighten the screws.
Place the universal mounting brackets over the
threaded mounting studs that are on the adaptor
plate.
Place one 5/16” fl at washer onto each threaded
mounting stud.
Thread one M8 nylon nut onto each threaded
mounting stud.
NB.
Before tightening the nylon nut, be sure that
both universal mounting brackets are level and
aligned with each other. If they are not aligned
and level, the fl at panel will not sit properly when
mounted to the EMPRO-WM175B.
Once the universal mounting brackets are level, use a
1/2” socket and socket wrench to tighten the M8 nylon
nuts. Do not over-tighten the screws.
6
7
Adaptor Plate
Griplate™
Mounting Hardware
Flat Panel
Adaptor Plate
Socket Wrench
Nylon Nut
Flat Washer
Universal Mounting
Bracket
8
