Installation
Insert a small straw or toothpick into the threaded
inserts found on the back of the fl at panel.
Use a pencil to mark the depth of the threaded
insert on the small straw or toothpick.
Mark the straw or toothpick 1/8” above the depth of
the threaded insert, as shown in Figure 1.
Insert the small straw or toothpick into the
remaining threaded inserts to compare and verify
their depth using the straw or toothpick’s 1/8”
allowance mark.
Locate the correct diameter screw for the threaded
insert.
If the screw you selected is longer than the 1/8”
allowance mark on the small straw or toothpick, as
shown in fi gure 2 and fi gure 3, do not use this screw.
The screw length must not bypass the mark.
Test each size of the screws provided.
The correct screws should thread easily into the
mounting point and not pull out when tension is
applied.
NB.
You must account for the bracket, spacers and
Griplate™ depths when using the Thread Depth
Indicator to measure the thread depth of your fl at
panel.
Universal Spacers Installation
If your fl at panel has uneven mounting points, or
recessed mounting points, please use the provided
universal spacers.
The universal spacer may be stacked six high, for a
total stacking height of 1-1/2”. The universal spacers
must be stacked in the direction shown above.
The universal spacers must be placed between the
mounting bracket and the fl at panel. The universal
spacer will fi t M4, M5, M6 and M8 screw sizes.
1
Determining the Mounting Hardware
1
2
3
4
Small Straw or Toothpick
Small Straw
or Toothpick
Small Straw
or Toothpick
Marking the 1/8”
Allowance
Depth Plus 1/8” Allowance
Mark
Depth Plus 1/8” Allowance
Mark
5
6
6
