Installation
The following steps must be performed by two
people.
Determine the desired viewing location. Use a stud
fi nder to locate two studs closest to the viewing
location.
Once the studs have been located, use a pencil to
mark the centre of each stud.
NB. A minimum of two (2) wall studs must be used in
the installation of this product.
When determining viewing height, the centre of
the TV should be at eye level while sitting in an
upright position. When using the fl at panel as room
decoration, raise it to the point where the bottom of
the screen is at eye level while sitting and the top is
eye level when standing.
Drill a pilot hole at the marked location using a
power drill and 1/4” drill bit.
NB.
Only use 1/4” drill bit when drilling the pilot
holes.
Two people must perform the installation. One
person must hold the mount whilst the other person
levels the mount. The mount must remain in place
while the mounting hardware is tightened .
Level the mount.
Align the mounting slot with the drilled hole.
Insert and tighten one 5/16” x 3” lag bolt and fl at
washer. Tighten using a 1/2” socket wrench. Do not
completely tighten the lag bolt at this time.
NB.
Do not overtighten lag bolts when attaching the
mount to the wall. Improper installation may result
in personal injury or damage to property.
1
2
3
Wood Stud Installation
1
2
3
Electronic Stud
Finder
Wall Stud
4
5
6
1/2” Socket Wrench
5/16” Lag Bolt
Flat Washer
Mounting Slot
Upper Mounting Channel
Wall Stud
1/4” Drill Bit
3
