Erbauer EDD12-Li-2, Оригинальное руководство пользователя

Страница: 12 / 37

23 22
TWO-SPEED GEAR CONTROL (D)
The drill has a two-speed gear control (3) designed for drilling or driving at LOW or HIGH
speeds. A slide switch is located on top of the drill to select either LOW or HIGH speed.
When using the drill in the LOW speed range, the speed will decrease and the drill will
have greater power and torque. When using the drill in the HIGH speed range, the speed
will increase and the drill will have less power and torque.
GEAR 1
Low speed range: for screw driving or working with large drilling diameter.
GEAR 2
High speed range: for working with small drilling diameter
BIT FITTING/REMOVING (E1)
To fit a bit, loosen chuck sleeve (1b) to open chuck jaws (1a). Insert the drill bit between the
chuck jaws and tighten chuck sleeve fully. Ensure the drill bit is in the centre of the chuck
jaws. To remove the bit, just loosen the chuck sleeve.
TORQUE ADJUSTMENT (E2)
In screw driving mode, the torque can be adjusted by rotating the torque adjustment ring
(2). Higher number means higher torque. Select the setting as follows:
1 - 4 for driving small screws
5 - 9 for driving screws into soft material
10-14 for driving screws into hard wood
15-17 for driving larger screws
For drilling in wood and metal with MAX torque
AUTOMATIC SPINDLE LOCK (F)
The automatic spindle lock allows you to use it as a regular screwdriver. You can give
an extra twist to firmly tighten a screw, loosen a very tight screw or continue working
when the battery energy has expired. For manual screwdriver purposes, the chuck is
automatically locked when the tool is off.
AUTOMATIC LED WORK LIGHT (G)
The LED work light (8) will illuminate when the trigger switch is depressed slightly, and
will automatically turn off a short while after the trigger switch is released. This provides
additional light on the surface of the workpiece for operation in lower light situations.
WARNING!
Do not look directly into LED light.
DRILLING
When drilling into a hard smooth surface, use a centre punch to mark the desired hole
location. This will prevent the drill bit from slipping off centre as the hole is started. Hold the
tool firmly and place the tip of the bit at the point to be drilled. Depress the switch trigger to
start the tool. Move the drill bit into the workpiece, applying only enough pressure to keep
the bit rotating. Do not force or apply side pressure to elongate a hole.
WARNING!
When drilling in metal, only use HSS drill bits in good
condition. Always use a magnetic bit holder (not included) when using short
screwdriver bits. When screw-driving, apply a small quantity of liquid soap or
similar to the screw threads to ease insertion.
Where possible, secure smaller work pieces to prevent them from moving
during operation.