Erbauer EDD12-Li-2, Оригинальное руководство пользователя

Страница: 13 / 37

25 24
OVERLOAD, TEMPERATURE AND CHARGING PROBLEM
Problem Tool/ Battery
Status
Possible cause Solution
Overload
protection
Product suddenly
Stops; The LED
work light is flashing
Extremely high
torque, binding
and stalling
situations,overloading
of the tool
Relieve the load
immediately, reset the tool
by switching off and back
on again
Temperature
extremely
high
Product suddenly
Stops;The LED
work light is flashing
Battery temperature
exceeds 70°C during
operating
Cool down the battery to
below 70°C for operation
Low charge Product suddenly
Stops;The LED
work light is flashing
quickly
The battery pack’s is
under 15% charge
Remove the battery pack
from the tool and charge it
Other
problems
Short charges Not fully charged Make sure that the battery
is fully charged every time
by allowing the charger to
complete its full charging
cycle
Poor storage
condition
Always unplug the
charger when not in use
and store in a dry secure
place; Avoid charging
or storing your battery
in temperatures below
5°C and above 40°C.
Cool down a hot battery
pack from a tool that has
just been operated for
approximately 30 minutes
before storage
CARE & MAINTENANCE
MAINTENANCE
Your tool requires no additional lubrication or maintenance. There are no user serviceable
parts in your power tool. Never use water or chemical cleaners to clean your power tool.
Wipe clean with a dry cloth. Always store your power tool in a dry place. Keep the motor
ventilation slots clean. Keep all working controls free of dust. Occasionally you may see
sparks through the ventilation slots. This is normal and will not damage your power tool.
RECYCLING AND DISPOSAL
Waste electrical products should not be disposed of with household waste.
Please recycle where facilities exist. Check with your Local Authority or retailer
for recycling advice.
For further information visit www.recycle-more.co.uk
DISPOSAL OF AN EXHAUSTED BATTERY PACK
To preserve natural resources, please recycle or dispose of the battery pack
properly. This battery pack contains Li-Ion batteries. Consult your local waste
authority for information regarding available recycling and/or disposal options.
Discharge your battery pack by operating your tool
,
then remove the battery pack
from the tool housing and cover the battery pack connections with heavy-duty
adhesive tape to prevent short circuit and energy discharge. Do not attempt to
open or remove any of the components.
REPAIR
This product does not contain any parts that can be repaired by the consumer. Contact an
authorised service centre or a similarly qualified person to have it checked and repaired.
STORAGE
• Switch the product off and remove the battery pack.
• Clean the product as described above.
• Store the product and its accessories in a dark, dry, frost-free, well- ventilated place.
• Always store the product in a place that is inaccessible to children.
• We recommend using the original package for storage or covering the product with a
suitable cloth or enclosure to protect it against dust.
TRANSPORTATION
• Switch the product off and remove the battery pack.
• Attach transportation guards, if applicable.
• Always carry the product by its handle.
• Protect the product from any heavy impact or strong vibrations which may occur during
transportation in vehicles.
• Secure the product to prevent it from slipping or falling over.