Erbauer EDD12-Li-2, Оригинальное руководство пользователя

Страница: 34 / 37

11 10
USE
01 INTENDED USE
This charger is solely for the charging of batteries listed in the TECHNICAL
SPECIFICATION section.
CHARGING YOUR BATTERY PACK (A)
WARNING!
The charger and battery pack are specifically designed to
work together so do not attempt to use any other devices. Never insert or
allow metallic objects into your charger or battery pack connections because
an electrical failure and hazard will occur.
1. Slide the battery pack onto the charger.
2. Connect the charger to a suitable power supply.
3. The LED lights on charger show different status as below.
RED LED GREEN LED STATUS REMARK
On Off HOT/COLD Battery The charger will recover to charge
when the temperature drops to
40°C or raises to 5°C
Flashing Off Defective Battery pack or charger is defective
Off Flashing Charging
Off On fully charged Disconnect charger from power
supply and remove battery pack
from charger
WALL-MOUNT HOLES (B)
The charger has hanging holes for convenient storage. Install screws in the wall 4 inches
(101.6 mm) apart. Use screws sufficiently strong to hold the combined weight of the
charger and battery pack .
CARE & MAINTENANCE
WARNING!
Remove the plug from the socket before carrying out any
adjustment, servicing or maintenance.
Your battery charger requires no additional lubrication or maintenance. Never use water
or chemical cleaners to clean your charger. Wipe clean with a dry cloth.
Always store your charger in a dry place.
ENVIRONMENTAL PROTECTION
Waste electrical products should not be disposed of with household waste.
Please recycle where facilities exist. Check with your Local Authority or retailer
for recycling advice. For further information visit www.recycle-more.co.uk.
PLUG REPLACEMENT
If you need to replace the fitted plug, then follow the instructions below.
IMPORTANT: The wires in the mains lead are coloured in accordance with the following
code:
BLUE – NEUTRAL BROWN – LIVE
As the colours of the wire in the mains lead of this product may not correspond with the
coloured marking identifying the terminals in your plug, proceed as follows. The wire,
which is coloured blue, must be connected to the terminal, which is marked with N or
coloured black. The wire, which is coloured brown, must be connected to the terminal,
which is marked L or coloured red.
Connect
Blue to N
(neutral)
Outer sleeve
firmly clamped
Cable
grip
Brown L
(live)
5 AMP fuse approved to BS 1362