25
NOTE:
Take care of small parts that are removed during assembly or
when making adjustments. Keep them secure to avoid loss.
02
Setup
Battery pack
Release / Attach
1. Lock the On/Off switch (12) to avoid accidental starting by moving the forward /
reverse rotation control (6) into the middle position (See below section “Controls –
Forward / reverse rotation control”).
2. To remove the battery pack, press down the release button (10a) and pull out the
battery pack (10) from the battery pack holder (7a) (Fig. A).
3. Align and slide the battery pack (10) to the battery pack holder (7a). Ensure that it
clicks in place (Fig. B).
Charging the battery pack
The battery has been shipped in a low charge condition. Charge it fully before first use.
Refer to the charger instruction manual for the details.
Battery capacity indicators
The battery pack (10) is equipped with battery capacity indicators (10b) which are
used to give an indication of the battery pack’s remaining capacity. Press the battery
capacity button (10c) to check battery capacity (Figs. C, D). The LEDs will stay lit for
approximately 5 seconds.
Belt clip
The belt clip (9) can be assembled on either side of the combi drill.
1. Set the forward / reverse rotation control (6) in the middle positon (lock).
2. Attach the belt clip (9) properly to the slot and fix it with screw (8) in clockwise
direction (Fig. E).
3. The belt clip (9) can be hooked on your belt or pocket, etc (Fig. F).
MNL_Erbauer_ECD12-Li-2_GB_12V Combi Drill_V10_210422.indd 25
4/22/21 6:20 PM
Содержание 5059340010762
