Epson PowerLite 737c Projector
2/05
Epson PowerLite 737c Projector
-
17
3. Click
Use IP connect mode
, then click
OK
. You see this
screen:
4. Click
IP connection
. You see this screen:
5. Enter the projector’s IP address and click
Search
.
The IP address appears in the Projector list and a
searching icon displays.
If the search fails to find a projector with the specified IP
address, the searching icon turns into a question mark.
If this happens, run EasyMP to check the projector’s IP
address, then repeat this step.
Note:
If you still don’t see the projector, make sure the Internet
connection firewall is disabled.
6. Click the projector you want to connect to, then click the
Connect
button. If more than one projector is listed, you
can select additional projectors and connect to them at the
same time.
7. If you are prompted for a keyword, enter the four-digit
number displayed on the EasyMP Network screen and
click
OK
.
Removing the Wireless 802.11 b/g Card
Follow these steps to remove the card from your projector.
1. If you’re running NS Connection, click
Disconnect
on the
control bar.
2. Check the card access light to make sure it isn’t flashing.
Caution:
Never remove the card while the card access light is green or
flashing. You may damage the card or lose data.
3. Press the eject button. The button pops out.
4. Press the eject button again. The wireless card partially
ejects.
5. Pull the card straight out. Then press the eject button back
in to prevent it from being damaged.
Indicates
search in
progress
Click here
Eject button
Access light
