Epson Photo PC-750Z, Руководство по обслуживанию, Страница: 68 / 94

EPSON PhotoPC-750Z Revision A
Adjustment Overview 68
Figure 5-9. Screen when uploading Firmware
5. Select the new Firmware and press “Open”.
6. LED located on the front side of the camera (if TB2 board is
removed, LED can not be seen) blinks for about 20 seconds to
indicate that the uploading is being performed correctly.
Figure 5-10. Screen when uploading Firmware
B u t t o n f o r F i r m w a r e U p l o a d i n g
O p e n
L o o k i n :
F i l e N a m e ( N ) :
F i l e s o f T y p e ( T ) :
O p e n
C a n c e l
C A U T I O N
„
If the power supply is stopped or the serial
communication cable comes off during the
uploading of Firmware , this may lead to destroy the
Flash Memory. Therefore, do not perform other
operation until “Complete” is indicated.
„
In the firmware, there are 2 types of specification;
NTSC or PAL. Do not upload the firmware for PAL to
NTSC, or its opposite. (However, there is a protection
function on the program)
C a u t i o n I n d i c a t i o n I n d i c a t i o n o f p r o c e s s o f u p l o a d i n g