Epson Photo PC-750Z, Руководство по обслуживанию, Страница: 61 / 94

EPSON PhotoPC-750Z Revision A
Adjustment Overview 61
Table 5-2. Required Instruments
5.1.1 Getting Ready for Adjustment
This section explains camera and PC setting up for adjustment. Follow
the procedures below and complete the setting-up.
1. Use PC with Windows  95. (See the details below)
No. Name Purchasable Code
1 5100 Kelvin Color Viewer X 103058400
2
DscCalDl_121a
adjustment program
X
Attached with this
manual book.
3 Simens Chart X
Included in the end
of this book.
4 Precision Driver (+) O ----
5 Simens Star Chart X 10428B100
6 Color Marix O B740200100
7 Soldering Iron O B641000100
8 Tweezers O ---
9
Windows95 or 98 (require
19200 bps or higher for
serial)
O ---
Note) O means commercially available and X means not.
W A R N I N G
„
Disconnect the AC adapter or remove batteries
before disassembling the camera.
„
Discharge the electricity in the electrolytic
condenser(C5412) by using the cement resistance.
The electrolytic condenser, which is mounted on the
ST1 board, is for light emission and is charged
automatically every time the power is turned on.
Therefore, if you need to touch the ST1 board for
repair service, you must release the electricity in the
condenser. (See Chapter 4 for more details)
C A U T I O N
„
IBM

-compatible PC with 486 or higher processor.
„
3.5-inch high-density diskette drive
„
Serial port with standard RS-232C interface
„
8 MB RAM
„
Hard disk drive with at least 15 MB available
„
VGA or SVGA monitor with at least 256-color display.
„
Error indication “Camera is not connected” will be
displayed, when you try to activate the program
without turning the power of the camera On.