The Printer Setting Utility starts.
2. Click the
Printer Settings Report
tab.
3. Select
TCP/IP Settings
from the list on the left side of the page.
The
TCP/IP Settings
page is displayed.
If the IP address shows
0.0.0.0
(the factory default) or
169.254.xx.xx
, an IP address has not been
assigned. To assign one for your printer, see “Assigning an IP Address (for IPv4 Mode)” on
page 31.
Disabling the Firewall Before Installing Printer Drivers
If you are running one of the following operating systems, you must disable the firewall before
installing print drivers:
❏
Windows 7
❏
Windows Vista
❏
Windows Server 2008 R2
❏
Windows Server 2008
❏
Windows XP
The following procedure uses Windows 7 as an example.
1. Click
Start
—
Help and Support
.
Note:
For Windows Vista, Windows Server 2008, Windows Server 2008 R2 and Windows 7 operating
systems, if you use
Online Help
, switch to
Offline Help
on
Windows Help and Support
window.
2. In the
Search Help
box, enter
firewall
and then press the
Enter
key.
In the list, click
Turn Windows Firewall on or off
and then follow the instructions on the screen.
Enable the firewall after the installation of the printer software is complete.
AL-M200 Series User’s Guide
Printer Connection and Software Installation
37
Содержание AL-M200 Series
Страница 1: ...User s Guide NPD4751 01 EN ...
Страница 186: ...4 Lower the levers to the original position 5 Close the rear cover AL M200 Series User s Guide Troubleshooting 186 ...
Страница 220: ...6 Place the printer at a new location and replace the paper tray AL M200 Series User s Guide Maintenance 220 ...
Страница 228: ... Enquiries on repair service and warranty AL M200 Series User s Guide Where To Get Help 228 ...