Epson ACULASER COLOR 1000, Руководство по обслуживанию

Страница: 56 / 230

EPSON AcuLaser C2000 / AcuLaser C1000 Revision E
Product Descriptions Control Panel (AcuLaser C1000) 56
†
Duplex Printing
Selects simplex printing or duplex printing.
NOTE: AcuLaser C1000 permits duplex printing only when the paper
size is A4 or LT. With any other paper size, selection of duplex
printing is invalid, displaying the error message “Can't print
duplex”.
†
RITech
The RITech function is enabled or disabled by RITech setting.
†
Toner Save
Selects whether the Toner Save function is enabled or disabled.
†
Top Offset
Sets the print starting vertical position on a sheet.
The printer permits setting in the range of about -30.0 ~ 30.0 mm in 1-dot
increments, while setting by the driver is limited to -9 ~ 9 mm in 1-millimeter
increments.
Binding margins for duplex printing with the Top Offset setting value are
limited to 0 ~ 30 mm in 1-millimeter increments.
†
Left Offset
Sets the print starting horizontal position on a sheet.
The printer permits setting in the range of about -30.0 ~ 30.0 mm in 1-dot
increments, while setting by the driver is limited to -9 ~ 9 mm in 1-millimeter
increments.
Binding margins for duplex printing with the Top Offset setting value are
limited to 0 ~ 30 mm in 1-millimeter increments.
†
Paper Type
Printing speed, fuser temperature and other necessary settings are
determined for the paper type for use.
†
Size Ignore
Selects whether or not to ignore the errors “Paper Set” and “Check Paper
Size”.
†
Avoid Error
Selects whether or not to avoid occurrence of any of the followings:
“Paper Set”, “Invalid Size”, “Mem Overflow”, “Duplex Mem Overflow”
ON: The printer continues printing without displaying any of the above
errors.
“Paper Set” does not occur, but “Check Paper Size” appears if the
paper size of the fed sheet is not as designated.
None of “Invalid Size”, “Mem Overflow”, and “Duplex Mem
Overflow” occurs, but “Print Failure” appears.
OFF: Once any of the aforementioned errors occur, the printer will not
recover until receiving a release command through the
ESCPAGES-02 protocol.
NOTE: “Avoid Error” is intended not to suspend the printer for an
extended period of time under conditions where sufficient
monitoring of the printer is not available, for example, in the
case of printing with the printer used as a shared printer.
1.5.3.3 Setting Items Requiring Control by the Printer for
Each Printing or Status Change (AcuLaser C100)
Table 1-37. Setting Items Requiring Control by the Printer
for Each Printing or Status Change
Control Item Range of Values
Total Pages 0 ~ 99999999 pages
Color Pages 0 ~ 99999999 pages
MP Tray Feed Counter 0 ~ 150 pages
LC 1 Feed Counter 0 ~ 500 pages
LC 2 Feed Counter 0 ~ 500 pages
Jam Counts 0 ~ 65535 times
C Toner Change 0 ~ 255
M Toner Change 0 ~ 255
Y Toner Change 0 ~ 255
K Toner Change 0 ~ 255
Photoconductor Change 0 ~ 255
Oil Toll Change 0 ~ 255