Epiroc SB 1102, Инструкция по безопасности и эксплуатации

Страница: 23 / 32

Safety and operating instructions
© Construction Tools PC AB | 9800 1273 01 | 2020-04-03
Original Instructions
23
4. Carefully clean the bore and the lower bushing seat
area.
5. Mount new O-rings on the new lower bushing.
6. Lubricate the new lower bushing and mount it. Use a
plastic sledgehammer to insert the lower bushing.
7. Mount a new scraper ring.
8. Mount the locking pin. Rotate the lower bushing until
the locking pin finds its position in the lower bushing.
9. Lock the locking pin by mounting a spring pin with a
sliding hammer.
7.5 Every year
Overhauling must be done after one year of continuous
operation. Overhauling must for safety reasons be per-
formed by authorised personnel at an authorised work-
shop.
8 Storage
WARNING Heavy hydraulic breaker and working
tool
The hydraulic breaker and the working tool are heavy
equipment. If the breaker or working tool topple over or
fall down from where they are stored, it can result in ma-
terial damage and personal injury.
u Store the hydraulic breaker and the working tool so
that falling or rolling down is prevented.
If the hydraulic breaker is not used for a long time, the
following steps have to be considered to protect the hy-
draulic breaker from corrosion:
1. Clean the hydraulic breaker carefully.
2. Dismount the working tool and lubricate the front part
of the piston, bushing and the tool retainer lock.
3. Store the hydraulic breaker in a dry place.
9 Disposal
A used machine must be treated and scrapped in such a
way that the greatest possible portion of the material can
be recycled and any negative influence on the environ-
ment is kept as low as possible.
Before a used machine is scrapped it must be emptied
and cleaned from all hydraulic oil. The remaining hy-
draulic oil must be deposited and any negative influence
on the environment is to be kept as low as possible.