http://www.GuitarAmplifierPCBs.com
“Baby Will” Valve Junior Conversion
Version 4
Build Manual
22 September 2009
28 of 36
8.1.2 The Baby Will PCB and Tube Hardware
Lay the Baby Will down into the EVJ chassis with the tube sockets toward the
chassis and the diodes toward the power rocker switch. Align the standoffs with
their respective holes and fasten a screw into the standoff(s) near the power
transformer.
Do not tighten them down.
Install and fasten the volume and tone controls and the input jack into the chassis.
Slide the volume and tone knobs onto the pot stems and fasten with the set
screw.
It should look like this when you’re
done.
NOTE: Tube hardware is not required
for this build. The parts list
provides them for you. These
should be aligned, drilled, and
installed prior to installing the
circuit board.
Make sure the screws used to mount the tube hardware do not contact
the circuit board or any component on the inside of the chassis.
Here’s a closer look at the controls.
