Networking
71
DVI Broadcaster DL User Guide
10.3.2
Set the DVI Broadcaster DL to use a DHCP server
By default, the DVI Broadcaster DL is configured to connect to a network using a
DHCP server, the DHCP server will automatically configure the network settings and
assign a relevant IP address to the DVI Broadcaster DL. This section describes how to
re-enable DHCP settings if they have been disabled.
1.
Log into the Web admin interface.
2.
Select
Network
from the main menu.
3.
Select
Use DHCP
.
4.
If required, in the
MTU Size
field specify the largest packet size permitted
for Internet transmission. If this value is too large for the connection, it
may result in packet loss or dropping Internet connection.
5.
The other fields can be left as is.
6.
Select
Apply
to save these changes.
7.
Select
Maintenance
.
8.
Select
Reboot Now
. It takes a few minutes for the DVI Broadcaster DL
device to reboot.
9.
After a few minutes log into the Web admin interface. Logging into the
Web admin interface can be done by:
a.
See the section
Network Discovery of the
on how to obtain the IP
address for DVI Broadcaster DL
b.
Using a browser and browsing to the new IP address assigned to
the DVI Broadcaster DL.
c.
Using the Network Discovery Utility, see section Logging into the
Web Admin Interface for more details.
10.
Re-log into the Web admin interface using the administrator username and
password.
The following diagram shows the network page from the Web admin interface and
enabling DHCP.
Содержание DVI Broadcaster DL
