Epilog Laser LEGEND 24EX 6000, Руководство пользователя

Страница: 92 / 236

Section 8: Using the Epilog Legend Systems
78
Liquid Crystal Display (LCD)
The Legend EX is equipped with a 320 x 240 pixel LCD graphic display. This is
shown above located just to the left of the keyboard commands. The menu choices
are listed across the top of the display, much like that of your personal computer. The
bottom of the display shows the current machine status, along with job information.
The center section is
used for drop down
menus and for
displaying images.
In the event of an error,
there will be a flashing
bar just above the status
bar that will give an
error message.
The LCD menu headings and settings are discussed in the following sections.
Setup
The “ Setup” menu allows you to manually set the systems Speed and Power. It also
provides the On/Off function for the red dot pointer on the machine. The
Speed/Power settings in this menu command will be over-ridden if the job was sent
with “
Computer Controlled Speed/Power” selected in the print driver.
Speed
To set the “ SPEED ”, turn the “ JOG/SHUTTLE KNOB” to the desired numeric
value. The choices range from 0.1 to 100. The lowest number will allow your
machine to move very slowly and the highest will set the machine to run at its fastest.
Power
To set the “POWER” , turn the “ JOG / SHUTTLE KNOB ” to the desired numeric
value. The choices range from 1.0 to 100. A lower number reduces the depth of cut.
A higher number increases depth of cut.