Epilog Laser FiberMark Fusion 13000, Руководство пользователя

Страница: 130 / 202

Section 8: Using the Front Control Panel
116
change permanent. Most users find it is easier to make this setting from the
ECC.
10. Subnet Mask – This sets the Subnet mask for the laser system. Center click to
gain access, tilt the joystick up or down to increment or decrement. Tilt left or
right to move to the different sets of three numbers. Press the Go key to make
your change permanent. Most users find it is easier to make this setting from
the ECC.
11. Gateway – This sets the Gateway for the laser system. Center click to gain
access, tilt the joystick up or down to increment or decrement. Tilt left or right
to move to the different sets of three numbers. Press the Go key to make your
change permanent. Most users find it is easier to make this setting from the
ECC.
12.
Laser Installed - This shows which type laser is installed in the machine - CO2
or Fiber – If your machine has blue panels it is a CO2. If your machine has
yellow panels it is a fiber.
CO2 lasers are the most versatile and work with many different types of
materials. Fiber lasers are used for metal marking only.
This is a factory setting that is not user accessible.
13. Vector Grid In – This indicates if the Vector Grid is installed. Center click to
gain access, tilt the joystick up or down to toggle between Yes and No. Press
the Go key to make your change permanent. Most users find it is easier to make
this setting from the ECC.
14. AirA Raster – This tells the machine to activate Air assist during all Raster
jobs. Center click to gain access, tilt the joystick up or down to toggle between
Yes and No. Press the Go key to make your change permanent. Most users set
this setting to No. Most users find it is easier to make this setting from the ECC.
15. AirA Vector - This tells the machine to activate Air assist during all Vector
jobs. Center click to gain access, tilt the joystick up or down to toggle between
Yes and No. Press the Go key to make your change permanent. Most users set
this setting to Yes. Most users find it is easier to make this setting from the
ECC.
16. Laser Match – This sets the left-right raster line alignment. This setting is
normally a factory only setting and will not need to be adjusted by the user.