Epilog Laser FiberMark Fusion 13000, Руководство пользователя

Страница: 129 / 202

Section 8: Using the Front Control Panel
115
4. Y Home – This is a calibration function that insures your artwork is properly
located on the table in the Y-axis. It is set relative to the upper left corner of the
table.
Increasing
this number has the effect of moving your artwork down.
Decreasing
this number has the effect of moving your artwork up.
The numeric readout shows increments of .001”.
Center click to gain access, tilt the joystick up or down to increment or
decrement. Press the Go key to make your change permanent.
5. Table Home – This is a calibration function that insures your auto focus
distance is set properly. It establishes the correct spacing between the focus lens
and the top of the table. It insures that the table always moves the top of your
work piece to a point that is exactly two inches below the focus lens (or, three
inches for the Fiber lens) when auto focus is used.
Increasing
this number has the effect of increasing the distance between the
table and the lens carriage.
Decreasing
this number has the effect of decreasing the distance between the
table and the lens carriage.
The numeric readout shows increments of .001”.
Center click to gain access, tilt the joystick up or down to increment or
decrement. Press the Go key to make your change permanent.
6. Jog Laser PWR – This function sets the laser power that will be used when
using the Laser On feature. Increasing this number increases the percentage of
the laser power that will be used when Jogging the lens carriage and pressing
the white Laser On button.
Center click to gain access, tilt the joystick up or down to increment or
decrement. Press the Go key to make your change permanent.
7. ♦ Quick Table Home – A center click will move the table down to find the
nearest table height sensor. This function is rarely used.
8. Serial # - This establishes a S/N for USB use. Center click to gain access, tilt
the joystick up or down to increment or decrement. Press the Go key to make
your change permanent. This function is rarely used.
9. IP Address – This sets the IP Address of the laser system. Center click to gain
access, tilt the joystick up or down to increment or decrement. Tilt left or right
to move to the different sets of three numbers. Press the Go key to make your