CLEANING YOUR RANGE
• Turn off and unplug the range from the power outlet, make sure all surface units are off and cool before
removing anything, then remove all items including shelves and rack.
• Wash the inside surfaces with a warm water and baking soda solution. The solution should be about 2
tablespoons of baking soda to a quart of water.
• Wash the shelves and rack with a mild detergent solution.
• The outside of the range should be cleaned with mild detergent and warm water.
• Wring excess water out of the sponge or cloth when cleaning area of the controls, or any electrical parts.
• Wash the outside cabinet with warm water and mild liquid detergent. Rinse well and wipe dry with a clean soft cloth.
• Do not use steel wool or steel brush on the cook-top.
CLEANING SURFACE UNITS AND REFLECTOR BOWLS
• Turn off and unplug the range from the power outlet, to make sure that
burners are off and cool before removing burners and reflector bowls.
• Removing the burners and reflector bowls as following:
• Lift the edge of the unit opposite from the receptacle, just enough to
clear the reflector bowl.
• Pull the surface unit gently out of the mounting receptacle.
• After the unit has been removed, the reflector bowl can be lifted out of
their mounting.
• Clean the burners and reflector bowls with mild detergent and warm water. Wring excess water out of the
sponge or cloth when cleaning them.
• Replace the burners and reflector bowls as following:
• Line up the opening of the reflector bowls with the burners receptacle, hold the surface unit as level as
possible with the terminal just positioned into the receptacle, then push the surface units’ terminal into
the receptacle.
• When the terminal is pushed into the receptacles as far as it will go, push down the edge of the surface unit
opposite the receptacle.
NOTE:
Do not immerse burners in water or any other liquids.
LIFT-UP COOKTOP
You can access the area beneath of the cooktop for cleaning purposes by
lifting up the cooktop. As always, ensure the range is unplugged from the
power outlet before cleaning.
• Hold the cooktop from front left and right corners of cooktop and pull it up.
• After lifting up the cooktop high enough, set the support rod into place
as shown.
• Leave the cooktop on the tip of support rod.
• Wipe with warm soapy water. Use a soapy steelwool pad on heavily
soiled areas.
• To lower the cooktop, lift the cooktop holding from the front edge.
Replace the support rod to its previous place. Lower the cooktop in its
place. During replacement of the cooktop, be sure that the front edge
of cooktop covers the upper edge of control panel.
NOTE:
Do not drop the cooktop. Personal injury or damage to the cooktop frame could result.
