EP Equipment JX0-30, Руководство по эксплуатации

Страница: 65 / 74

REV. 08/2019
1
H
H Troubleshooting
This chapter is designed to help the user identify and rectify basic faults or the results of incorrect
operation. When locating a fault, proceed in the order shown in the table.
If the fault cannot be rectified after carrying out the remedial procedure, notify the manufacturer ’ s
service department ,as any further troubleshooting can only be performed by specially trained and
qualified service personnel.The manufacturer has a customer service department specially trained
for these tasks.
Fault Probable Cause Action
Truck does
not start.
• Battery connector not connec
ted.
• Key switch in “OFF” position
• Safety gates open
• EMERGENCY DISCONNECT
switch pressed
• Foot switch not pressed
• Battery charge too low
• Faulty fuse
• truck in charge mod
• Check the battery connector and
connect if necessary.
• Set key switch to “ON”
• Close the safety gates
• Unlatch EMERGENCY
DISCONNECT switch
• Press foot switch
• Check battery charge, charge battery
if Necessary
• Test fuses
• Interrupt charging
Load cannot
be lifted
• Hydraulic oil level too low
• Excessive load
• Fuse blown
• Check the hydraulic oil level
• Note maximum capacity (see data
plate)
• Check fuses
To provide targeted and rapid response to faults, the following details are useful and important to
provide for the customer service department:
Truck serial number
Display unit error number (if present)
Error description
Current location of truck.
•
•
•
•