REV. 07/2020
7
E
Hoisting the truck
This section explains the attachment of lifting equipment to the truck for the purpose of
hoisting. Many methods of rigging to a crane or hoist are possible. Explanation of such
methods as well as operation of lifting equipment is outside the scope of this manual. Both
the attachment of lifting equipment to the truck and the hoisting operation itself must be
performed by personnel experienced in hoisting.
Lifting equipment of insufficient capacity can fail and cause severe injury or death.
Ensure that all lifting slings, hardware, or other equipment has sufficient capacity to carry the
weight of the truck. Refer to the truck data plate for truck weight. If a battery is installed, its
weight must be added to the truck weight listed on the data plate. Switch the truck off and
press the emergency stop button. Attach lifting equipment to the holes in each side of the
chassis. Attach lifting equipment to the fork tips to keep the truck approximately horizontal as
it is lifted.
WARNING
1.6
Handle and handle lever installation
1.7
Control Handle
Bracket
Bend Wire
Controller Wire
Steel Wire
(1)
Steel Wire
Screw
Hand-operated
valve
(2)
Fig1113-00021OM
i
NOTE
Plug the connector of bend wire into controller wire.
First, touching hand-operated valve.
The steel wire
(
2
)
rising up Buckle end of the steel wire
(
1
)
into end of the steel wire
(
2
)
from manual.
Release the steel wire
(
2
)
and tighten the adjust screw.
•
•
•
