REV. 07/2020
2
E
The truck is equipped with a static-return-to-neutral function. If the control handle is held in
its working range (M) when the truck is turned on, the travel function will not operate. The
control handle must then be returned to either end position and then moved back into its
working range to enable travel.
Switching the truck off
To turn the truck off, remove the key from its slot.
Press the emergency stop switch.
Driving, steering, braking
Driving
Operators must be familiar with all safety procedures
that apply to truck operation before driving.
Read and understand all safety information in
Section C before operating the truck.
Tilt the control shaft into the driving range (M) and
set the controller to the desired direction (V or R).
Steering
Steering the truck is done using the control handle. Manually moving it to the left or right will
swivel the drive wheel. The truck then turns in forward or reverse according to the handle
direction.
Emergency stop
Push the emergency stop switch. All of the electrical functions are switched off.
Braking
The braking behaviour of the truck strongly depends on the state of the floor. This must be
taken into account by the driver for his driving behaviour.
The truck can be braked in three ways:
by using the generator brake (controller)
by counter-current braking (controller)
by using the service brake (control shaft)
Braking using the generator brake:
Release the drive switch.
•
•
•
•
1.2.2
R
V
R
V
M
B
B
