REV. 07/2020
3
E
•
•
In hazardous situations set the control handle to the brake position or set the travel switch to
the opposite direction.
WARNING
If the travel switch moves slowly or not at all to 0, the truck must be taken out of service until
the cause of this fault is be rectified.
WARNING
When driving on a hill or uneven roads, please lift fork to stop the bottom of fork and the
ground being rubbed.
Loading
CAUTION
Before lifting a load, ensure that its weight does not
exceed the truck’s maximum load capacity.
Refer to the rated load capacity specified on the truck’s
nameplate.
Ensure that the load is stable and uniform to prevent
any partial spillage.
Check that the width of the load is compatible with the
width of the forks.
If the control handle moves slowly or not at all to the upper brake zone, the truck must be
taken out of service until the cause of this fault is be rectified.
Replace the gas pressure spring if necessary.
WARNING
WARNING
1.2.3
Counter-current braking:
While driving, switch the controller to the opposite direction.
The truck is decelerated by counter-current braking until it starts moving in the opposite
direction. In case of emergency, the service brake must be used to brake the truck.
Braking using the service brake:
Tilt the control shaft upwards or downwards into one of the braking ranges (B).
•
