07
08
2
.
2
Display
If any cargo is placed on the frame, its weight will be displayed after 1 second; once “ dynamic cursor”
disappears, value as displayed on the screen will be the weight of the cargo.
2
.
3 Key function.
Display function
Zero key (“ 0” ) ---Reset instrument readings within the permissible range.
Tare removal key ( “T” )---Current weight is taken as the tare weight for tare removal based
on the gross weight; whereas the instrument is to be switched over to the net weight for
display. Recover the tare weight as deducted at the net weight, and switch the instrument
to the gross weight for display.
Unit switch key ( “U” )---It is for cyclic switching of measurement unit among KG, T, OZ and
LB, representing “ kilogram” , “ ton” , “ ounce” and “ pound” respectively.
ON/OFF key (“ P”) ---Once this key is pressed and held for 2 seconds under ON status, “ -----”
is to be displayed on the screen before power-off; press the key for a while to turn on the back
light in the back light mode. Press the key for a while for start-u
Combination key function
“U” key + “0” key - Factory reset
“U” key + “T” key - enter the parameter setting mode
①
②
3
.
Parameter setting mode
3.1Operating panel
Figure 3-1 Operating panel in parameter setting mode
1
Input value
Calibration unit
Input cursor
Option selection
Option confirmation
Location switching
Option cancellation
2
3
4
5
6
7
Press “ U” key and “ T” key simultaneously in normal display mode to enter the parameter setting mode when
“SETUP” is displayed on the screen. The function of the individual key is as follows:
“0” key - option selection
Press “ T” key to confirm entry into parameter setting mode; press “ U” key to cancel parameter setting
to enter normal display mode.
Operating Instructions
E20V Series Scale Pallet Trucks
“T”
key - option confirmation.
“U” key——option cancellation
“P” key - digit switching in calibration mode.
