Installation of handles
03
04
Adjusting the finger grip handle
1.Make sure the chain on the handle
is in this position shown in the picture.
2.Push the handle shaft through the
holes,Fix it with the spring pin.
3.Put the chain through the hole on the shaft.
4.Fix the chain in the slot of the
unloading plate.
5.Pull the shaft from the hole. Then
the assembly is complete.
On the handle of this pallet truck, you can find finger grip control handle(1-1) which can be regulated in
three positions :
Lifting-set the control handle at lower position
Middle position: set the control handle at middle position
Lowering: set the control handle at upper position. The handle moves back to the middle position when
released.
1
2
3
However if the truck cannot operate normally under three positions, you can adjust them according to the
following steps:
①
If the forks elevate while pumping in the Middle position, turn the adjusting nut (2-4) on the adjusting bolt
(2-3) or screw (2-6) clockwise until pumping action does not raise the forks and the finger grip control handle
works properly Middle position .
1
-
1
Upper
Middle
Lower
2
-
3
2
-
4
2
-
6
E20V Series Scale Pallet Trucks
②
If the forks descend while pumping in the Middle position, turn the screw(2-6) or nut(2-6) counter
clockwise until the forks stop descending.
③
If the forks do not descend when the finger grip control handle (1-1) is in the Lowering position, turn
the nut (2-4) or screw (2-6) clockwise until raising the control handle lowers the forks. Then check the
Middle position according to items
and
②
to make sure the nut (2-4) and screw(2-6) are in the proper
①
position.
④
If the forks do not elevate when the finger grip control handle is in the Lifting position, turn the nut
(2-4) or screw (2-6) counterclockwise until the forks elevate. Then check the function of the Lowering
position and Middle position according to items
,
②
and
③
is normal.
①