9
GB
Sauna bus connector
in the control unit
After the installation and power connection to
the control unit (stand-by) the green status LED
on the remote switch module board will start
to
fl
ash slowly to con
fi
rm it is operational.
Switch the sauna on and make a quick oper-
ation test in order to ensure that the switch
module functions properly.
After the positive test as the
fi
nal step attach
the decoration strip to the wooden cover. First
insert it at the bottom and then press it at the
upper part until the holders snap in (as shown
on
fi
g. 7).
Operation
The remote switch module and the button will
be automatically detected and con
fi
gured.
In the standby mode the status LED lamp in the
button will not light on. Green status LED on
the board will
fl
ash slowly.
Press the button for at least 3 sec to switch the
sauna on. The sauna will switch on with the last
saved parameters.
The button LED lamp will now light on contin-
uously red to indicate the active heating mode.
The red status LED on the board will light on
as well.
Press the button again shortly to switch the
sauna o
ff
. The button LED lamp will go out to
con
fi
rm the standby mode.
By control units with humid operation (Bi-O)
the sauna-dry mode will normally switch on af-
ter the operation. In such case the button LED
will
fl
ash slowly to indicate this mode.
If the button LED lamp starts to
fl
ash rapidly
then some kind of fault is present.
Please refer to the operation manual of the con-
trol unit for troubleshooting if necessary. Make
sure to check the sauna heater.
The sauna heater will not start if the remote
switch button is pressed while the status LED
lamp
fl
ashes rapidly.
Remove the protective plastic foil from the dec-
oration strip.
small groove shall be at the top
fi
g. 5
fi
g. 6
fi
g. 7
Druck Nr
. 29344600 / 10.14
Jumper
braun / brow
n
gelb / yellow
grün /green
weiß / wh
ite
Status LED red
Status LED green
