45
EN
The control unit is equipped with a “Switch-off”
rocker switch.
You will find this switch on the top side of the
housing by Econ series control units.
This switch allows to switch the control unit to
the standby mode (notice the heating will not
start), to switch the control unit completely off
(disconnect from power) or to switch the con-
trol unit off but to leave the light switched on.
Notice: if you leave the Econ control units
switched off for more than 24 h the time set-
ting will be lost. Other settings will be saved.
You will have to repeat setup and re-confirm
the settings.
Attention!
Parts of the printed cir-
cuit board will still remain energized in the
switched off condition! Risk of electric shock!
Device switched on.
Position I.
Device switched off
(completely);
Position 0.
Light enabled;
Device switched off.
Position II.
The device „Switch-off“ switch
Switch setting 0
Press the switch on the lower side of the rocker
to the first latch (
switch setting 0
). The switch
will be in the middle position. The unit is now
completely switched off (disconnected).
Switch setting II
To turn the light on in the cabin while the unit
is still disconnected (for maintenance and clea-
ning) push the left side of the rocker to the sec-
ond latch (
switch setting II
).
Switch setting I
To make the unit ready for operation, switch back
to the initial position (
switch setting I
). The unit
will return to stand-by mode.
Device switched on.
(default Position I)
Note!
When switching the switch-off rocker from
Pos. I to Pos. II, you will be at the intermediate
position 0 for approx. 1s.
Switch-off rocker
Reset control to factory settings:
Restart control via the switch-off rocker and keep the buttons
MODE
,
,
pressed. After the
appearance of the picture, press the keys
MODE
,
for > 3 sec.
