16
GB
Using the sauna
Finnish sauna operation
Press the button to switch on the sauna
heater. The display alternately shows the
current time and the set temperature (factory
setting 95° C). The green operating LED
comes on and as long as the sauna heater
is on, the red heating LED is also displayed.
95°
15:00
Steam operation
A suitable vaporizer unit up to 3 kW and 230
V AC is required for steam operation. The
control unit „clocks“ the vaporizer based on
the user-set steam level.
Please note:
During the activation of the
vaporizer, the oven heats with only two
phases; that is, one of the switch phases is
switched to the vaporizer.
In the case of the symmetrically wired oven
(equal heating power for each phase), one-
third of the heating power of the sauna oven
is consequently switched off. This serves
both to protect the user from excessive
temperatures as well as to limit the switch
capacity to 3 kW per phase.
The humidity level aimed for depends stron-
gly on the confi guration of the sauna cabin,
the type of sauna oven used and the
power of the vaporizer. Therefore, it is im-
portant that you fi nd your personal climate
zone. Always choose the temperature fi rst
(from 30 to 60°C) and then the steam level.
Temperature
Relative humidity
60°C
50 %
50°C
60 %
40°C
70 %
30°C
80 %
These amounts are reachable, although they
are higher than the amounts actually needed.
Therefore, reduce the amounts after the pre-
heat cycle; to do so, set a lower value using
the program key. Please note that the cabin
temperature is highest under the cabin ceiling,
although the relative humidity is proportionally
The vaporizer is always activated when an
amount between 1 and 100% is shown in the
display. When the display shows 0, please
note that the vaporizer is not activated, but as
with steam operation in general, the maximum
temperature in the cabin is limited to 70°C.
Please note also that the vaporizer starts up
only after the temperature falls to this level.
Содержание ECON 45H2
Страница 2: ...2 English 3 Русско 28 ...
