www.enware.com.au Call 1300 369 273
9
installation in-wall
MOUNTING THE SENSOR PLATE
The stainless steel sensor plate is always
mounted flush to the wall. Feed the
transformer cable through the conduit and
make the connection to the sensor by joining
the line plug and socket, observing the polarity
of the plug.
Fix the sensor panel using four screws
provided.
WARNING:
Sensor components are fragile and sensitive.
Do not force the sensor plate to fit onto wall,
or attempt to disassemble sensor components,
as this could result in damage to sensor and
would void warranty.
INSTALLING THE SPOUT
Apply thread sealant on 1/2” BSP male thread.
Screw on the wall base with a spanner and
fix onto plate with the back nut. Loosen grub
screw on the spout, slide onto wall base, then
tighten the grub screw to fix the spout in
position.
Connect water supply from the outlet of the
solenoid to the spout.
TESTING
Turn on the power to the unit and test the unit.
See Operating Instructions overpage.
TESTING
Turn the water on and check for leaks. Connect all electrical components together temporarily,
and test the tap. Once correct operation of the tap is confirmed, disconnect the sensor plate and turn
off the power to the transformer. The tap is now ready for sheeting or finishing of the wall.
installation after the wall is finished
IMPORTANT:
Before fixing the sensor plate to wall,
apply a thin bead of silicone sealant
behind the plate along the top and
side edges. Ensure that the plate is
thoroughly sealed to the wall and that
no water can get in behind the plate.
Any water entering behind the sensor
plate will cause damage to sensor
components and void warranty.
APPLY
THREAD TAPE
TR-20 TORX
